300M V6-3.5L VIN G (2000)
Hose/Line HVAC: Service and Repair
A/C Discharge Hose/Line Replacement
REMOVAL
1. Remove refrigerant from the A/C system using a refrigerant recovery machine.
A/C Pressure Transducer And Discharge Line
2. Disconnect A/C pressure transducer wire harness.
3. Disconnect discharge line at compressor using a 6 mm allen wrench.
CAUTION: Cap all lines that are not being replaced and cap the expansion valve tubes.
4. Disconnect line at A/C condenser using a M13 Hex wrench.
INSTALLATION
For installation, reverse the above procedures. Then, tighten bolts to 23 N.m (17 ft. lbs.) at condenser and compressor.
