300M V6-3.5L VIN G (2000)
2. Tighten the wheel lug nut, pulling the wheel stud into the flange of the hub and bearing assembly. When the head of the stud is fully seated against
the bearing flange, remove lug nut and washers from wheel stud.
3. Install the rotor on the hub and bearing assembly.
4. Install front brake caliper back over braking disc and align with caliper mounting holes on steering knuckle. Refer to Disc Brake Caliper in Brakes
and Traction Control for the caliper installation procedure. Install the caliper to steering knuckle guide pin bolts and tighten to a torque of 19 Nm
(168 inch lbs.).
5. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
6. Lower the vehicle to the ground.
