300M V6-3.5L VIN G (2000)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor
The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing. The bottom of the sensor sits above
the drive plate.
REMOVAL
1. Disconnect electrical connector from Crankhaft Position Sensor.
2. Remove sensor mounting screw. Remove sensor.
INSTALLATION
1. Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten
the retaining bolt to 12 N.m (105 in. lbs.) torque.
2. Connect electrical connector to Crankhaft Position Sensor.
