300M V6-3.5L VIN G (2000)
Wire Repair
4. Spread the strands of the wire apart on each part of the exposed wire (Example 1).
5. Push the two ends of wire together until the strands of wire are close to the insulation (Example 2).
6. Twist the wires together (Example 3).
7. Solder the connection together using rosin core type solder only. Do not use acid core solder.
8. Center the heat shrink tubing over the joint, and heat using a heat gun. Heat the joint until the tubing is tightly sealed and sealant comes out of both
ends of the tubing.
9. Secure the wire to the existing ones to prevent chafing or damage to the insulation.
10. Connect battery and test all affected systems.
Special Tools
Probing Tool Package 6807
