300M V6-3.5L VIN G (2000)
Fuel Pump Relay: Description and Operation
AUTOMATIC SHUT DOWN (ASD) AND FUEL PUMP RELAYS - PCM OUTPUT
The ASD relay and fuel pump relay are located in the Power Distribution Center (PDC) near the battery. A decal on the inside of the PDC covers
shows the locations of each relay and fuse contained in the PDC.
The PCM operates the Automatic Shut Down (ASD) relay and fuel pump relay through one ground path. The PCM operates them by switching the
ground path for the relays on and off. Both relays turn on and off at the same time.
The ASD relay connects battery voltage to the fuel injectors and ignition coil. The fuel pump relay connects battery voltage to the fuel pump.
The PCM turns the ground path off when the ignition switch is in the Off position. Both relays are off. When the ignition switch is in the On or
Crank position, the PCM monitors the crankshaft position sensor and camshaft position sensor signals to determine engine speed. If the PCM does
not receive a crankshaft position sensor signal and camshaft position sensor signal when the ignition switch is in the Run position, it de-energizes
both relays. When the relays are de-energized, battery voltage is not supplied to the fuel injectors, ignition coil and fuel pump.
