300M V6-3.5L VIN G (2000)
FIGURE 9
20.
Remove the screws that secure the lower right center bezel to the I/P glove box opening. Disengage the two (2) snap clips and then remove the
lower right center bezel (Figure 9).
21.
Remove the right side I/P top pad screws (3) and bolts (2).
22.
Remove the screw above the radio location that secures the center of the I/P top pad.
23.
Disconnect the speaker electrical connectors and harness clips on the top of the I/P.
24.
Remove the I/P sun sensor (if equipped).
25.
Remove the upper I/P top pad nuts (4) and screws (5) and then disconnect the defroster duct clips from the I/P top pad.
26.
Remove the I/P top pad.
FIGURE 10
27.
Disconnect the passenger airbag wiring harness connector (Figure 10).
28.
Remove the two (2) screws that secure the two airbag module end bracket mounting tabs to the front of the I/P structural duct (Figure 10).
29.
Remove the two (2) screws that secure the passenger airbag module end bracket rear mounting tabs to the rear of the I/P structural duct (Figure
10).
