300M V6-3.5L VIN G (2000)
30.
Remove the passenger airbag module and set it aside for return.
NOTE:
Do NOT attempt to deploy the airbag module. All airbag modules must be returned to the supplier.
31.
Install the new passenger airbag module.
32.
Install the two (2) screws that secure the passenger airbag module end bracket rear mounting tabs to the rear of the I/P structural duct (Figure 10).
Tighten the screws to 105 in-lbs (11.8 N.m).
33.
Install the two (2) screws that secure the two airbag module end bracket mounting tabs to the front of the I/P structural duct (Figure 10). Tighten
the screws to 105 in-lbs (11.8 N.m).
34.
Connect the passenger airbag wiring harness connector (Figure 10).
35.
Install the I/P top pad.
36.
Connect the defroster duct clips to the I/P top pad and install the I/P top pad screws (5) and nuts (4).
37.
Install the I/P sun sensor (if equipped).
38.
Connect the I/P speaker electrical connectors and harness clips.
39.
Install the screw above the radio location that secures the center of the I/P top pad.
40.
Install the right side I/P top pad screws (3) and bolts (2).
41.
Install the lower right center bezel (Figure 9). Tighten the screws that secure it to the I/P glove box opening securely.
42.
Install the right I/P end cap to the top pad and glove box opening (Figure 8). Tighten the screws securely.
43.
Install the glove box door.
44.
Install the left side I/P top pad screws (2).
45.
Install the two (2) nuts that secure the center support bracket to the transmission tunnel (Figure 6).
46.
Install the two (2) screws that secure the I/P to the center support bracket (Figure 6).
47.
Install the I/P cluster.
48.
Install the steering column opening cover (Figure 5).
49.
Install the I/P cluster bezel.
50.
Install the HVAC control unit.
51.
Install the radio.
52.
Install the radio bezel.
53.
Connect the heated seat switch, lighter and auxiliary power outlet electrical connectors and then install the ash tray bezel.
54.
Install the front bin into the center floor console.
55.
Install the left and right A-Pillar trim panels.
56.
Install the cover (Figure 4). Make sure that the four (4) snap clip retainers are engaged.
57.
With the ignition switch in the ON position, connect the negative battery cable.
58.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
59.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
