300M V6-3.5L VIN G (2000)
3. Install washer on end of tension strut. Install a NEW tension strut to cradle bracket nut, on tension strut. Tighten the tension strut to cradle bracket
retaining nut to a torque of 130 Nm (95 ft. lbs.). When torquing tension strut nut, keep tension strut from turning by holding tension strut at flat
using a large open end wrench.
4. Install the wheel and tire assembly.
5. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
6. Lower the vehicle to the ground so the suspension is supporting the vehicles full weight (control arm at design height). Tighten the lower control
arm pivot bushing to cradle bracket attaching bolt to a torque of 142 Nm (105 ft. lbs.).