300M V6-3.5L VIN G (2000)
1. Install new motor on regulator by positioning motor gearbox so that it engages regulator sector teeth.
2. A slight rotational or rocking movement may be necessary to bring three motor gearbox screw holes into proper position.
3. Install three gearbox screws and one tie down bracket screw, if applicable. Tighten to 5.6 to 8 Nm (50 to 70 in. lbs.) torque.
4. Install regulator. Using the switch, test operation of motor. See: Window Regulator
5. Install trim panel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Procedures
6. Connect the negative battery cable remote terminal to the to the remote battery post.