300M V6-3.5L VIN G (2000)
Washer Fluid Level Switch: Service and Repair
REMOVAL
Negative Battery Cable Remote Terminal
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body).
4. Disconnect the wire connector from the reservoir fluid level sensor.
Washer Reservoir
5. Gently pry sensor away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remover rubber grommet from reservoir and throw away.
INSTALLATION
For installation, reverse the above procedures.