Aspen 2WD V8-4.7L (2007)
Antenna, Navigation: Service and Repair
Installation
INSTALLATION
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
1. Position antenna to instrument panel.
2. Connect antenna to radio.
3. Install radio.
4. Install and tighten mounting fasteners.
5. Install instrument panel defroster grille.
6. Install passenger airbag.
7. Connect battery negative cable.
