Aspen 2WD V8-4.7L (2007)
Parking Assist Control Module: Service and Repair
Installation
INSTALLATION
1. Position the park assist module (5) to the left quarter inner panel, behind the power liftgate module (3) to the rear of the C-pillar (2) and above the
left rear wheel housing.
2. Secure the module to the left quarter inner panel using three plastic push-in fasteners (4).
3. Reconnect the two body wire harness connectors (1) to the module connector receptacles.
4. Reinstall the trim onto the left quarter inner panel.
5. Reconnect the battery negative cable.
