Aspen 2WD V8-4.7L (2007)
Parking Assist Distance Sensor: Description and Operation
Description
DESCRIPTION
Vehicles equipped with the park assist system have four park assist sensors (1) installed on the rear bumper fascia. Only the membrane (3) of each sensor
is visible through a hole in the outer vertical surface of the fascia. The remainder of each sensor including the sensor mounting bracket, the sensor spacer
and the sensor wiring connection is concealed behind the fascia. A sensor wire harness behind the fascia connects the sensors to the vehicle electrical
system.
Each of the four sensors is identical in construction and is interchangeable. The electronic circuitry and a communication chip for each sensor is enclosed
and protected within the molded black plastic sensor housing. The housing includes an integral connector receptacle (4) and two integral latch tabs (2).
The sensor membrane extends from the surface of the sensor housing, and is finished to match or contrast with the outer surface of the fascia.
A resilient O-ring spacer around the circumference of each of the four sensor membranes (2) isolates the membrane from the openings in the fascia (1).
Each sensor is snapped into its own dedicated molded plastic mounting bracket. Each mounting bracket is heat-staked to the back side of the rear fascia.
The park assist sensors cannot be adjusted or repaired. If ineffective or damaged they must be replaced. The sensors and the spacers are each available
for individual service replacement.
