Aspen 2WD V8-4.7L (2007)
Front Door Window Glass Weatherstrip: Service and Repair
Weatherstrip-Front Door Belt Outer
Removal
REMOVAL
1. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
2. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking
tabs (3) working from back to front.
NOTE: Typical outer belt molding design shown.
3. Slide molding out from under the side view mirror and remove.
Installation
INSTALLATION
1. Position the outer belt molding onto the door and position forward under the side view mirror. Seat the molding fully.