Aspen 2WD V8-4.7L (2007)
CAUTION: Verify brake hose (3) is not twisted or kinked before tightening fitting bolt.
2. Install the banjo bolt (1) with new copper washers (4) to the caliper (2). Tighten to 18 Nm (155 in. lbs.)
3. Install the caliper slide pin bolts. Tighten to 32 Nm (24 ft. lbs.)
4. Remove the prop rod from the vehicle.
5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.
6. Install the tire and wheel assembly.
7. Lower the vehicle.
Rear
REAR
1. Install caliper (4) to the caliper adapter (7).
2. Coat the caliper mounting slide pin bolts (2) with silicone grease. Then install and tighten the bolts to 15 Nm (11 ft. lbs.).
3. Install the brake hose banjo bolt (5) and new copper seal washers if caliper was removed.
4. Install the brake hose (3) to the caliper (4) with and tighten fitting bolt to 18 Nm (155 in. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
5. Remove the prop rod from the vehicle.
6. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.
7. Install the wheel and tire assemblies (6).
8. Remove the supports and lower the vehicle.
9. Verify a firm pedal before moving the vehicle.
Front
FRONT
