Aspen 2WD V8-4.7L (2007)
10. Install accessory drive belt.
11. Fill Cooling system.
12. Install air cleaner assembly, resonator assembly and air inlet hose.
13. Connect battery negative cable.
Installation - Left Side
INSTALLATION - LEFT SIDE
CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gasket as necessary.
2. Install cylinder head cover and hand start all fasteners. Verify that all studs are in the correct location shown in.
3. Tighten cylinder head cover bolts (1) and double ended studs to 12 Nm (105 in. lbs.).
4. Install left side breather and connect breather tube.
5. Connect injector electrical connectors and injector harness retaining clips.
6. Install the resonator and air inlet hose.
7. Connect negative cable to battery.
