Aspen 2WD V8-4.7L (2007)
20. Align the two actuator couplers (1) with the mode-air door pivot shafts and install the couplers into the left side of the HVAC housing. Be sure to
install the couplers with the coupler arm located between the two stop tabs on the HVAC housing.
21. Install the blend door actuator (3) and the mode door actuators (4) and retaining screws onto the HVAC housing (5).
22. Install the evaporator temperature sensor (2) into the top of the HVAC housing.
23. Connect the HVAC wire harness (1) to the evaporator temperature sensor, blend door actuator and the mode door actuators.
24. If removed, install the recirculation door actuator (3) to the air inlet housing (5).
25. Install the air inlet housing onto the top of the HVAC housing (1).
26. Install the screws (4) that secure the air inlet housing to the HVAC housing. Make sure the HVAC wire harness retainer is properly installed.
