Aspen 2WD V8-4.7L (2007)
27. Connect the HVAC wire harness to the recirculation door actuator (3).
28. Install the HVAC housing.
29. If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. When replacing multiple
A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system. Use
only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
Rear HVAC Housing
ASSEMBLY
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to
the refrigerant system.
NOTE: If the rear A/C evaporator is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant
oil of the type recommended for the A/C compressor in the vehicle.
1. If removed, install the two actuator couplers (1) into the rear HVAC housing. Be sure to install the couplers with the coupler arm (3) located
between the two stop tabs (4) on the HVAC housing.
2. Install the blend-air door (1) and the mode-air door into the rear HVAC housing (2).
