Aspen 2WD V8-4.7L (2007)
5. Install the nut (1) that secures the A/C liquid line to the A/C condenser. Tighten the nut to 22 Nm (16 ft. lbs.).
6. Remove the tape or plugs from the liquid line fitting and the receiver/drier (3).
7. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified O-ring as it is made of
a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
8. Connect the front section of the A/C liquid line (2) to the receiver/drier.
9. Install the bolt (1) that secures the front section of the A/C liquid line to the receiver/drier. Tighten the bolt to 13.5 Nm (120 in. lbs.).
10. Install the air cleaner housing (1) to the right side of the engine compartment.
11. Reconnect the negative battery cable.
12. Evacuate the refrigerant system.
13. Adjust the refrigerant oil level.
14. Charge the refrigerant system.
REAR SECTION
