Aspen 2WD V8-4.7L (2007)
Electrical Accessory Panel: Service and Repair
Module-Integrated Power
Removal
REMOVAL
1. Disconnect the negative and positive battery cables.
2. Unsnap cover and remove the B+ terminal nut from the integrated power module (IPM). Remove the B+ cable.
3. Remove the IPM from the retaining bracket (1).
4. Disconnect the connectors from the (IPM).
5. Remove the Front Control Module (FCM) (2) retaining screws.
6. Disconnect the front control module by pulling it straight off the integrated power module.
Installation
INSTALLATION
1. Install the Front Control Module (FCM) (2) to the Integrated Power Module (IPM).
