Aspen 2WD V8-4.7L (2007)
1. Place accelerator pedal assembly (4) over two mounting studs (3).
2. Install and tighten two mounting nuts (5). Refer to Torque Specifications.
3. Install electrical connector (1) to APPS (6).
4. A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
5. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
6. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTCs) from PCM.
7. Before starting engine, operate accelerator pedal to check for any binding.
