Aspen 2WD V8-4.7L (2007)
Blower Motor Relay: Service and Repair
Controls - Rear
Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Locate the junction block (JB) (1) on the left side of the passenger compartment behind the cowl side trim panel.
3. Remove the rear blower motor relay (2) from the JB.
Installation
INSTALLATION
1. Position the rear blower motor relay (2) into the proper receptacle of the junction block (JB) (1).
2. Align the rear blower motor relay terminals with the terminal cavities in the JB receptacle and push down firmly on the relay until the terminals are
fully seated.
3. Reinstall the cowl side trim panel.
4. Reconnect the negative battery cable.