Aspen 2WD V8-4.7L (2007)
16. Align the seat belt anchor cover (2) to the opening near the rear of the outboard seat side shield (3). Using hand pressure, press firmly and evenly
on the cover until it snaps into place.
17. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
Second Row - Center
SECOND ROW - CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the second row seat belt and retractor (2) between the seat back foam pad and frame (1) as a unit.
2. Engage the two tabs (4) on the retractor bracket into the keyed slots in the seat back frame.
3. Install and tighten the three screws (3) that secure the retractor to the seat back frame. Tighten the screws to 27 Nm (20 ft. lbs.).
