Aspen 2WD V8-4.7L (2007)
Lateral Accelerometer: Service and Repair
Installation
INSTALLATION
1. Install the dynamics sensor (2) on the studs (4) to the vehicle.
NOTE: Make sure the electrical connector is facing toward the rear of the vehicle.
2. Connect the electrical connector (3) to the sensor (2).
3. Install the two retaining nuts (1) and tighten to 6 Nm (53 in. lbs.).
4. Install the floor console.
5. Perform the ABS verification test with the scan tool. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test
