Aspen 2WD V8-4.7L (2007)
Drive/Propeller Shaft: Service and Repair
Installation
INSTALLATION
1. Slide slip yoke (1) onto automatic transmission/transfer case output shaft (2) with reference marks aligned.
2. Align reference marks on propeller shaft flange (2) and pinion flange (1). Install new companion flange (1) bolts and tighten to 115 Nm (85 ft.
lbs.)
NOTE: Flange bolts incorporate a Loctite(R) patch, new bolts should be used. If bolts are not available, clean bolts and apply Mopar(R)
Lock & Seal Adhesive or equivalent to the threads.
CAUTION: Failure to follow these instruction may result in a driveline vibration.
