Aspen 2WD V8-4.7L (2007)
Window Track: Service and Repair
Door - Front
Removal
REMOVAL
1. Raise the glass to the full up position.
2. Remove the watershield. Refer to Front Door Panel.
3. Remove the nuts (2) and disconnect the electrical connector (3), if equipped.
4. Remove the side view mirror (1).
5. Separate the inner belt molding from the mounting flange from the rear to the front.
6. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
7. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking
tabs (3) working from back to front.
NOTE: Typical outer belt molding design shown.
