Aspen 2WD V8-4.7L (2007)
Window Track: Service and Repair
Doors - Rear
Removal
REMOVAL
1. Raise glass to the up position and remove the watershield. Refer to Rear Door Panel.
2. Remove the inner belt molding.
3. Remove the bolt and nut (3) and remove the front channel.
4. Remove the door glass as necessary.
5. Remove the bolt (4) and remove the rear glass run channel and stationary glass (1).
Installation
INSTALLATION
1. Install the rear glass run channel and stationary glass (1) into the door and seat fully along the door frame.
2. Install the bolt (4) and tighten to 9 Nm (80 in. lbs.).
3. Install the door glass as necessary except for the inner belt molding.
4. Install the front glass run channel and install the bolt and nut (3).