Aspen 2WD V8-4.7L Flex Fuel (2009)
NOTE: Install new copper washers on the banjo bolt when installing
1. Install the disc brake caliper (2) to the brake caliper adapter (3).
CAUTION: Verify brake hose (3) is not twisted or kinked before tightening fitting bolt.
2. Install the banjo bolt (1) with new copper washers (4) to the caliper (2). Tighten to 18 Nm (155 in. lbs.)
3. Install the caliper slide pin bolts. Tighten to 32 Nm (24 ft. lbs.)
4. Remove the prop rod from the vehicle.
5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a complete system bleed
procedure must be performed.See: Brake Bleeding/Service and Repair.
6. Install the tire and wheel assembly, See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement.
7. Lower the vehicle.
Rear
REAR
1. Install the caliper (4) to the caliper adapter (7).