Aspen 2WD V8-4.7L Flex Fuel (2009)
Fog/Driving Lamp Bulb: Service and Repair
Fog Lamp Bulb - Removal
BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the fasteners that secure the front of the front fender wheel house liner to the bottom of the front fascia. See: Body and
Frame/Fender/Front Fender/Service and Repair/Front Fender - Removal.
3. Pull the front of the front fender liner rearward far enough to access the back of the front fascia.
4. Reach under and behind the front fascia to access the front fog lamp housing on the back of the front fascia.
5. Disconnect the wire harness connector (1) from the fog lamp bulb connector receptacle.
6. Firmly grasp the bulb on the back of the housing and rotate it counterclockwise (2) about 30 degrees to unlock it.
7. Pull the bulb straight out from the keyed opening in the housing.
