Aspen 2WD V8-4.7L Flex Fuel (2009)
16. Align the seat belt anchor cover (2) to the opening near the rear of the outboard seat side shield (3). Using hand pressure, press firmly and evenly
on the cover until it snaps into place.
17. Do not reconnect the battery negative cable at this time. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, the service
disconnect must also remain disconnected from the high voltage battery pack. The Supplemental Restraint System (SRS) verification test
procedure should be performed following service of any SRS component. See: Service and Repair.
Third Row Center
THIRD ROW CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Position the third row center seat belt and retractor (2) to the rear header (1) near the left D-pillar (3) as a unit.
2. Install and tighten the screw (4) that secures the retractor bracket to the inside of the rear header. Tighten the screw to 40 Nm (29 ft. lbs.).
3. Restore the top of the left upper D-pillar trim to its mountings on the D-pillar.
4. Route the seat belt and lower anchor latch plates through the clearance hole in the upper liftgate opening trim panel.
5. Reinstall the upper liftgate opening trim onto the inside of the rear header in the upper liftgate opening. See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Description and Operation/Rear Header Panel - Description.
Third Row Outboard
THIRD ROW OUTBOARD
