Aspen 2WD V8-4.7L Flex Fuel (2009)
Control Arm Bushing: Service and Repair
Front Lower Control Arm Bushings - Removal
LOWER CONTROL ARM BUSHINGS
1. Remove the lower control arm See: Service and Repair/Front Lower Control Arm - Removal.
2. Secure the control arm in a vise.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
LARGE BUSHING FRONT PART OF THE CONTROL ARM
1. Install the bushing tools C4212-F (Press)(1), (9334-4 (Driver)(2), 9334-6 (Spacer)(4) and 9334-5 (Receiver)(5) as shown for the replacement of
the large bushing (3).
SMALL BUSHING TORSION BAR SIDE
1. Install bushing remover tools C4212-F (Press)(1), 9334-4 (Driver)(2), 9334-6 (Spacer)(5) and 9334-5 (Receiver)(6) as shown for the small
bushing (3) removal.
