Aspen 2WD V8-5.7L (2007)
Power Steering Pump: Service and Repair
Pump
Removal
REMOVAL
1. Drain and siphon the power steering fluid from the pump.
2. Remove the serpentine drive belt.
3. Remove the reservoir return hose at the reservoir.
4. Remove the pressure hose from the pump.
5. Remove 3 pump mounting bolts through pulley access holes.
6. Remove the pump from the engine.
Installation
INSTALLATION
1. Align the pump with the mounting holes on the engine.
2. Install 3 pump mounting bolts through the pulley access holes. Tighten the bolts to 28 Nm (21 ft. lbs.).
3. Install the pressure hose to the pump. Tighten the pressure line to 37 Nm (27 ft. lbs.).
4. Install reservoir return hose to the reservoir.
5. Install the serpentine drive belt.
6. Fill the power steering pump.