Aspen 4WD V8-5.7L Hybrid (2009)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
Pinch Sensor - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove trim panel from liftgate, See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Removal.
3. Disconnect the pinch sensor wire harness connector (4).
4. Remove the clips/assembly holding the pinch sensor (2) to liftgate (1).
5. Feed the pinch sensor wire harness (5) out of the liftgate (1) and remove the sensor (2) from the vehicle.
