Aspen 4WD V8-5.7L Hybrid (2009)
1. Position the latch (2) into the liftgate and install the screws (3).
2. Tighten the screws to 11 Nm (95 in. lbs.).
3. Connect the electrical connector (1).
4. Insert the bent end of the latch actuator rod (2) to the swing clip on the latch (3), and snap clip onto rod.
5. Without changing the position of the liftgate outside handle, snap the grooved end of the rod (1) into the metal clip on the handle (4).
6. Install the trim panels. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Installation
Latch - Removal
REMOVAL