Aspen 4WD V8-5.7L Hybrid (2009)
1. Position the overhead console near the mounting location on the headliner.
2. Connect the infrared temperature sensor wire harness connector (1) (if equipped).
3. Connect the power sunroof/power liftgate switch wire harness connector (2) (if equipped).
4. Connect the reading lamp wire harness connector (3) (if equipped).
5. Connect the Electronic Vehicle Information Center (EVIC) module wire harness connector (4) (if equipped).
6. Align the snap clips on the overhead console housing with their receptacles in the overhead console bracket (2).
7. Push upward firmly and evenly on the sides of the overhead console housing (4) over the snap clip locations until the snap clips are fully engaged
with the overhead console bracket.
8. Reconnect the battery negative cable.
Overhead Console Bracket