Aspen 4WD V8-5.7L Hybrid (2009)
Lifter / Lash Adjuster: Service and Repair
Hydraulic Lifters - Removal
REMOVAL
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Perform the HEV high voltage power down procedure See: Hybrid Drive Systems/Battery System, Hybrid Drive/Service and Repair/Battery
System - High Voltage Power Down
2. Disconnect the 12 volt battery system ground isolation connector (1).
3. Remove the cylinder head See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head - Removal
4. Remove the tappet guide holder retaining bolt (1) from the tappet guide holder assembly (2).