Aspen 4WD V8-5.7L Hybrid (2009)
Rocker Arm Assembly: Service and Repair
Valve Rocker Arm - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
CAUTION: The longer pushrods are for the exhaust side and the shorter pushrods are for the intake side.
1. Install the pushrods in the same order as removed.
2. Install the pushrod retainer (1) 9070.
CAUTION: Make sure that the retainers (1) and the rocker arms (2) are not overlapped when tightening bolts or engine damage could result.
CAUTION: Due to the changes in the pushrod clearance holes in the Eagle 5.7L cylinder heads, close attention must be given when installing
the pushrod(s) into the tappet(s). Once the pushrod(s) have been installed, use a suitable light to look down through the pushrod
hole(s). This will allow you to verify the pushrod(s) are centered properly in the tappet(s) and avoid engine damage. Recheck after
the rocker shaft assembly has been installed and tightened to specification.
