Aspen 4WD V8-5.7L Hybrid (2009)
12. Install the cross bolts with new seal washers.
13. Using the sequence shown, tighten the cross bolts to 28 Nm (21 ft. lbs.).
14. Using the sequence shown, again tighten the cross bolts to 28 Nm (21 ft. lbs.).
15. Measure the crankshaft end play See: Crankshaft Main Bearing/Service and Repair
16. Position the connecting rods onto the crankshaft and install the rod bearing caps See: Connecting Rod/Service and Repair/Removal and
Replacement/Piston and Connecting Rod - Installation
17. Install the timing chain and sprockets See: Timing Components/Timing Chain/Service and Repair/Timing Chain & Sprockets - Installation
