Aspen 4WD V8-5.7L Hybrid (2009)
1. Position the rear A/C-heater control (2) near the center floor console.
2. Connect the wire harness connector (1) to the back of the rear A/C-heater control.
3. Insert the two locator tabs on the bottom of the rear A/C-heater control (1) into the two slots on the bottom edge of the floor console opening (2).
4. Rotate the rear A/C-heater control (3) forward far enough to align the two snap clips on the top of the rear A/C-heater control (4) with the
receptacles in the top edge of the floor console opening (5).
5. Using hand pressure, press the top edge of the rear A/C-heater control forward until the two snap clips are fully seated in into the receptacles.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
