Aspen 4WD V8-5.7L Hybrid (2009)
Drive Motor Power Relay: Service and Repair
High Voltage Negative Contactor - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Battery System, Hybrid
Drive/Service Precautions
WARNING: Once the battery cover is removed from the battery, high voltage is still present in the system even with the service disconnect
removed. When performing any diagnostic or service procedures, use extreme care with tools and other test equipment around
unisolated terminals and wires. Failure to take proper precaution could result in serious or fatal injury.
1. Connect the negative contactor electrical connector, install the contactor. Tighten to 3.4 Nm (30 in. lbs.).
2. Remove the high voltage Battery Cable Terminal Cover 10084 from the cable.
3. Install the negative high voltage wires to the contactor. Tighten to 3.4 Nm (30 in. lbs.).
4. Install the fan.
5. Install the fan mounting bolts. Tighten the bolts to 6 Nm (53 in. lbs.)
6. Connect the fan electrical connector (1).
7. Connect the wire clip from the fan housing (2).
