Aspen 4WD V8-5.7L Hybrid (2009)
Turn Signal Bulb: Service and Repair
Tail Stop Turn Lamp Bulb - Removal
BULB - CHRYSLER
NOTE: The rear lamp unit contains three bulbs: tail/brake/rear side marker (4), tail/turn (2), and backup (3). The service procedures for each
bulb are the same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the rear lamp unit (1) from the end of the quarter panel. See: Brake Lamp/Service and Repair/Tail Stop Turn Lamp - Removal.
3. Firmly grasp the appropriate bulb socket (2, 3, or 4) on the back of the rear lamp unit housing and rotate it counterclockwise about 30 degrees to
unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
