Aspen 4WD V8-5.7L Hybrid (2009)
Turn Signal Bulb: Service and Repair
Front Lamp Unit Bulb - Installation
BULB - PARK/TURN SIGNAL OR SIDE MARKER
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The front lamp unit contains three bulbs: headlamp (3), park/turn signal (2), and side marker (4). Except for the headlamp bulb, the
service procedures for each bulb are the same, only the bulb sizes and types may differ.
1. Align the base of the bulb with the appropriate park/turn signal (2) or side marker (4) bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the front lamp unit (1) housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the headlamp and dash wire harness connector to the appropriate park/turn signal or side marker bulb socket.
7. Reinstall the front lamp unit into the front fender. See: Service and Repair/Front Lamp Unit - Installation.
8. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.
