chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Procedures|Page 1641 > < Procedures|Page 1639
Page 13
background image

5. Install the secondary retaining clip (7) onto the refrigerant line coupler.

WARNING: Always follow vehicle service procedures to properly connect batteries on an HEV model. Serious or fatal injury may result from

improper service procedures.

6. On HEV models, reconnect the battery system using the service disconnect at the battery pack .  See: Hybrid Drive Systems/Battery System,

Hybrid Drive/Service and Repair

7. On gasoline only models, reconnect the negative battery cable.
8. Evacuate the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Evacuate.
9. Adjust the refrigerant oil level See: Heating and Air Conditioning/Specifications/Capacity Specifications/Refrigerant Oil Capacity.

10. Charge the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Charge.

Front

5.7L ENGINES

WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In

addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury 
See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions 

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air

Conditioning/Service Precautions/Warning  and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow the
warnings and cautions may result in possible serious or fatal injury.

CAUTION: Polyalkylene Glycol (PAG) oil can contaminate the refrigerant system of a Hybrid Electric Vehicle (HEV) and lead to A/C system

damage and failure. If the refrigerant recovery/recycling and charging equipment was last used on a non-HEV model, flush the
hoses of the equipment with a solvent approved by the equipment manufacturer before using the equipment on an HEV model, or
use refrigerant recovery/recycling and charging equipment designated only for HEV models by your service facility. See the
operating instructions supplied by the equipment manufacturer for proper use and care of the refrigerant recovery/recycling and
charging equipment.

NOTE: The A/C suction line on 5.7L engines is serviced in two sections.

FRONT SECTION

NOTE: 5.7L gas only engine shown. 5.7L HEV engine similar.

1. On HEV models, disconnect the battery system using the service disconnect at the battery pack   See: Hybrid Drive Systems/Battery System,

Hybrid Drive/Service and Repair.

2. On gasoline only engine models, disconnect and isolate the negative battery cable.
3. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
4. Raise and support the vehicle.
5. Remove the nut (3) that secures the A/C suction line (2) to the A/C compressor (5).

CAUTION: On HEV models, a small quantity of refrigerant oil may be lost from the A/C compressor when the A/C suction line is

disconnected. Prior to removing the A/C suction line from the A/C compressor, it very important to place a small clean container

Procedures|Page 1641 > < Procedures|Page 1639