Aspen 4WD V8-5.7L Hybrid (2009)
10. Reinstall the upper trim (1) onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Installation.
11. Position the seat belt turning loop (5) onto the height adjuster (2) on the upper B-pillar.
12. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
13. Engage the tab (2) on the lower edge of the trim cover (3) in the slot below the screw in the turning loop (1). Then press the upper edge of the trim
cover over the top of the turning loop until it snaps into place.
14. Position the front seat belt lower anchor (3) to the bracket on the outboard side of the front seat cushion frame.
15. Install and tighten the screw (2) that secures the lower anchor to the bracket on the outboard side of the front seat cushion frame. Tighten the screw
to 39 Nm (29 ft. lbs.).
