Aspen 4WD V8-5.7L Hybrid (2009)
9. Position the seat belt lower anchor (2) to the tapping plate (3) on the quarter inner panel.
10. Install and tighten the screw (1) that secures the lower anchor to the tapping plate. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Restore the third row seat cushion to its seating position.
Second Row - Center
SECOND ROW - CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Position the second row seat belt and retractor (2) between the seat back foam pad and frame (1) as a unit.
2. Engage the two tabs (4) on the retractor bracket into the keyed slots in the seat back frame.
3. Install and tighten the three screws (3) that secure the retractor to the seat back frame. Tighten the screws to 27 Nm (20 ft. lbs.).
