Aspen 4WD V8-5.7L Hybrid (2009)
Ball Joint: Service and Repair
Front Suspension Lower Ball Joint - Installation
INSTALLATION
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
1. Install the ball joint (3) into the control arm and press in using special tools C-4212F (press) (1), 9333-1 (Receiver) (2) and 9333-3 (Driver) (4).
2. Stake the ball joint flange in four evenly spaced places around the ball joint flange, using a chisel and hammer.
3. Remove the support for the halfshaft and install into position 4X4 only.
4. Install the steering knuckle See: Front Steering Knuckle/Service and Repair/Front Steering Knuckle - Installation.
5. Install the tie rod end into the steering knuckle See: Steering/Tie Rod/Tie Rod End/Service and Repair/Tie Rod End - Installation.
6. Install and tighten the halfshaft nut to 251 Nm (185 ft. lbs.). (If Equipped).
7. Install the brake caliper and rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation.
8. Install the tire and wheel assembly See: Wheels and Tires/Service and Repair/Removal and Replacement.
9. Check the vehicle ride height See: Alignment/Service and Repair.
10. Perform a wheel alignment See: Alignment/Service and Repair.
