Aspen 4WD V8-5.7L Hybrid (2009)
1. The rear wiper arm (1) must be indexed to the motor output shaft (3) with the rear wiper motor in the park position to be properly installed.
Position the rear wiper arm pivot end onto the motor output shaft so that the wiper blade is aligned with the alignment mark (4) located in the
upper margin of the lower liftgate glass blackout area on the lower right corner of the liftgate glass.
2. With the wiper arm properly indexed, push the tapered mounting hole on the pivot end of the wiper arm down over the output shaft.
3. Install and tighten the nut (5) that secures the arm to the shaft. Tighten the nut to 12 Nm (9 ft. lbs.).
4. Wet the liftgate glass, then operate the rear wiper. Turn the rear wiper switch to the Off position, then check for the correct wiper arm position and
adjust as required.
5. Insert the tab of the plastic cap (6) into the mounting hole on the side opposite the notch and press firmly on the notched side of the cap until it
snaps into place.
