Cirrus L4-2.4L VIN X (1998)
Fuel Injector: Description and Operation
Fuel Injector
OPERATION
All these engines use electrically operated top feed fuel injectors Fig. 30. The Automatic Shutdown (ASD) relay supplies battery voltage to the
fuel injectors. The PCM controls the ground path for each injector in sequence. By switching the ground paths on and off, the PCM fine-tunes
injector pulse width. Injector pulse width refers to the amount of time an injector operates.
The PCM determines injector synchronization from the camshaft position sensor and crankshaft position sensor inputs. The PCM grounds the
ASD and fuel pump relays after receiving the camshaft position sensor and crankshaft position sensor inputs.
The PCM energizes the injectors in a sequential order during all engine operating conditions except start-up. For the first injector pulse width
during start-up, all injectors are energized at the same time. Once the PCM determines crankshaft position, it begins energizing the injectors in
sequence.
Injector Resistance
The injectors are 12 ohm electrical solenoids.
