Cirrus V6-2.5L SOHC 24 Valve (1996)
Rear Door Window Glass: Service and Repair
Rear Door Glass
REMOVAL
1. Remove door trim panel and inner belt weatherstrip.
2. Connect power window switch or install crank and lower window to 50 mm (2 in.) from bottom of travel.
3. Loosen bolts holding rear lower run channel to inner door panel.
4. Separate rear run channel from door.
5. Loosen screws holding regulator roller channel to glass.
6. Slide roller channel rearward to allow screw heads to pass through key hole slots in channel.
7. Separate glass from roller channel.
8. Lift glass upward and out of the opening at top of door.
INSTALLATION
1. Lower door glass through opening at top of door.
2. Position door glass onto roller channel.
3. Slide roller channel forward to allow screw heads to engage key hole slots in channel.
4. Tighten screws holding regulator roller channel to glass.
5. Position rear run channel on door.
6. Tighten bolts holding rear lower run channel to inner door panel.
7. Install door trim panel and inner belt weatherstrip.
