Cirrus V6-2.5L VIN H (1995)
DURING INSTALLATION OF WINDOW BELT MOLDINGS.**
7.
Install rear window molding by placing radius of flag area over door flange. Push and seat molding flag posts into clips on door. Work molding
into place with heal of hand, starting in radius of flag and then two center clips. Check that flag is seated fully into clips. Install attaching screws.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-02-13-94
Install All Four Moldings
0.4 Hrs.
FAILURE CODE: P8 - New Part